PACK 8 - BUTTON

Pack 8 Contents

 Remove batteries before commencing!

Step 1> Disassemble the rear skid.

 

Step 2> Press the two nuts supplied into the bric as far as they will go

 

 Tip> Use your screwdriver to apply pressure when inserting the nuts to ensure they go all the way into position.

 

 Note> Whenever nuts or spacers are inserted into a bric the rounded ends must protrude as shown.

 

 Step 3> Align skid/spacer/bric assembly with the switch module and the centre two holes at the back of the motherboard (note orientation) and screw firmly into place.

Note> If any of these screws are not firmly tightened the button will not work.

 

 How your i-bot should look now.

I-BOT can now be switched on and off using his new button! I-BOT can also now read barcodes. To do this follow the instructions on the front of the activity mat.

See a QuickTime movie of i-bot reading a barcode

 Printable Barcodes Here 

 Watch the VIPER in action 6.5MB WMV file